| N |
ID |
English |
Czech |
| 2187 |
DRAW_BY_SPLINE_HINT |
Draw by closed spline. Use CTRL to add sharp edge. Doubleclick to end spline. |
add translation
|
| 2188 |
DRAW_BY_SRC_POLY |
Draw over polygones of source mesh. One click means painting the whole source polygon. |
add translation
|
| 2189 |
TRIAL_HINT |
Your copy of the program is not registered or your PC configuration was essentially changed. You can continue to work, but some functions will be disabled until you enter a valid serial number. The serial number is hardware independent, and you may only run one copy of 3D-Coat at a time. If we detect several times that you are using 3D-Coat simultaneously on several computers, your serial number will be disabled. If you are running 3D-Coat in different places don't forget to uninstall license in Help->Uninstall license otherwise someone may use your license and it will be disabled. |
add translation
|
| 2190 |
UNINST_LICENCE |
Uninstall license |
add translation
|
| 2191 |
UNINST_LICENCE_HINT |
This option allows you to uninstall the license on this PC and install it on other. You can install 3D-Coat on any number of PC's but you may not run it simultaneously on more than one PC at a time. |
add translation
|
| 2192 |
INVMASK_HINT |
Invert mask that is applied to all paint effects. |
add translation
|
| 2193 |
InvMask |
Invert mask |
add translation
|
| 2194 |
CAVITY_RADIUS |
Cavity radius |
add translation
|
| 2195 |
SCWorkMode_HINT |
Topological symmetry tool. First select 'Mark polygons' to define the symmetrical area by marking first the red polygon, then the blue one. Next choose the 'Copy using pen' option to copy surface attributes from one side to the other. |
add translation
|
| 2196 |
SCWorkMode |
Work mode: |
add translation
|
| 2197 |
SC_MARK_POLY |
Mark polygons. |
add translation
|
| 2198 |
SC_MARK_POLY_HINT |
Mark two adjacent polygons (one red and one blue) as the source and destination for topological symmetry. |
add translation
|
| 2199 |
SC_PEN_COPY |
Copy using pen |
add translation
|
| 2200 |
SC_PEN_COPY_HINT |
Copy surface parts from one side to the other by painting over the parts with the pen or mouse. |
add translation
|
