Jump to content
3DCoat Forums

Cloning tool improvement


rimasson
 Share

Recommended Posts

  • Advanced Member

Hello Andrew.

First, congratulation to you and your wife. :)

I'd like to have a small improvement to the cloning tool.

Actually, when i disable the Additive drawing, the height of the stroke depends on the radius of the brush. It's logical.

Let's say that i closed 3D coat, started a new session, and i want to sculpt with the same height.

The solution i thought about, is to use the cloning tool, right ?

The problem is , in traslation mode, the cloning source point MOVE.

Is it possible to add a new setting to the cloning tool, with a fixed source point ?

Is it possible also to have an option to use ALL the visible layers when i'm using a tool ? (for example, as a cloning source, or when i'm using the blur tool...)

Thanks.

Francois R.

Link to comment
Share on other sites

  • Advanced Member
Maybe it is better to make "depth picker" hotkey to pick depth from the current layer that corresponds to current pen radius? Then you can lock depth and use picked depth.

Well, if you can - go for it! :rolleyes: Its would be good addition.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...