Advanced Member ScrotieFlapWack Posted July 26, 2014 Advanced Member Report Share Posted July 26, 2014 So I have run into some issues. I don't know what I am missing. I have created a model in Silo 2, something very simple. I would like to UV it in 3D - Coat, however. When I go to mark the seams 3D - Coat isn't allowing me to select most of the edges of my model to mark the seams I don't know if it is an option I have missed, or whether there has been some slight change to the UV room since I last used 3D - Coat. Quote Link to comment Share on other sites More sharing options...
Carlosan Posted July 26, 2014 Report Share Posted July 26, 2014 Try this please Quote Link to comment Share on other sites More sharing options...
Advanced Member ScrotieFlapWack Posted July 28, 2014 Author Advanced Member Report Share Posted July 28, 2014 Hey Carlosan, thanks for the advise man. I have tried selecting the UV set's. I have made a new UV set as well and still have the same problem Quote Link to comment Share on other sites More sharing options...
Carlosan Posted July 29, 2014 Report Share Posted July 29, 2014 are you using retopo room, right ? Quote Link to comment Share on other sites More sharing options...
Advanced Member alvordr Posted July 30, 2014 Advanced Member Report Share Posted July 30, 2014 (edited) If you were doing retopo work with Symmetry on, consider using the apply symmetry to current layer. You might find that with symmetry active, you're not able to select the half that hasn't been applied, even though you're seeing it because symmetry is turned on. Edited July 30, 2014 by alvordr Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.