Member AlphaGrunt Posted August 28, 2014 Member Report Share Posted August 28, 2014 Hi guys, I'm having a small problem. This model is 2.5mil poly but when I use any of the tools or brushes to carve into it I get this unintended stepping? How do I create a super clean carve without all that? Thanks Quote Link to comment Share on other sites More sharing options...
Carlosan Posted August 28, 2014 Report Share Posted August 28, 2014 Please try Use Spacing = OFF Quote Link to comment Share on other sites More sharing options...
Member AlphaGrunt Posted August 28, 2014 Author Member Report Share Posted August 28, 2014 This seem right to you? Quote Link to comment Share on other sites More sharing options...
Contributor Solution BeatKitano Posted August 28, 2014 Contributor Solution Report Share Posted August 28, 2014 Don't use buildup, go slow with steady stroke (I usualy do 15). Some brushes behave beautifuly others... not. Buildup is one of the uglies. Try clay much better. And if you want absolute control over your stroke use splines... in fact everyone should just use splines... 1 Quote Link to comment Share on other sites More sharing options...
Member AlphaGrunt Posted August 31, 2014 Author Member Report Share Posted August 31, 2014 Thank you, very helpful!!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.